Installation Instruction -- Vinyl Floor Sticker

1.First Step, Clean up.

Before installation, the very first thing we gonna to do is to Clean up the area the stickers gonna to place.

Make sure the area is not wet, covered by dust or all diffent kind of dirt, this will weaken the adhesive and reduce the service life.

 

2.Second Step, Get your tools.

This tool will be really simple, a tape measure used for measurements, a clip board used for flaten the area, and a cutting tool -- A Sissor, an Ultility Knife..... as long as its sharp enough to cut.

 

3.Install

To install floor sticker, you need to take your measurement first, then put the peices on to the ground properly -- dont stick them now.

After doing this, you will see clearly which area are the places you gonna to fill, and how to cut the stikers to fit in these blanks.

Cut the extra stickers, place them into the area they should be.

After all these prep work, we are able to do the rest easily.

Pick up, peel the protection off, stick the sticker on to the ground. Meanwhile, you will need to using the clip board to scrape the sticker, this will get rid off the air bubble between the stiker and your floor.

Repeat the step, you will get a wonderful floor appears by your hand.

 

If you are still confusing, here's a vedio for teaching you how to install vinyl products.